At present, for many customers, the accuracy of lathe processing is still relatively high, and some corners or internal corners are also widely used. That is to saydeep hole drill bitSome industries cannot make too many mistakes in the operation process.

Deep hole drill operation we should pay attention:

1. The toolbox of the deep hole drill machine shall be placed in categories. Place them neatly and firmly, put them in a position convenient for operation, and keep them clean. Tools, knives, etc. Should be placed separately, to avoid the cutting edge of the tool collision, so as not to cause damage to the tool.

2. When working, all tools, measuring tools, fixtures and workpieces should be placed or concentrated near the operator as much as possible. They should have a fixed position, where to take them, which is good for drilling deep holes, and put them back in place after use.

3. Drawings, process cards, etc. It should be placed in an easy-to-read place, and care should be taken to keep it neat and complete to avoid unnecessary obsolescence.

4. The workpieces to be processed and the added workpieces should be placed separately and neatly for easy access and quality inspection.

5. The deep hole drill bit always keeps the working environment clean. Deep hole drill beds in Dongguan are grease-free.

6. The pedal of the deep hole drill machine used should be suitable, firm and clean.

and there is,deep hole drill bitHow to prevent the main failure of each component?

1. Advanced milling machine has graphic simulation display function. After entering the program, you can call the graphic simulation display function to observe the motion trajectory of the deep hole drill in detail, so as to check whether the deep hole drill may collide with the workpiece or fixture.

2. Use the idle function. Use the idling function of the machine to check the correctness of the trajectory of the deep hole drill. When the program is input to the machine, you can load a deep hole drill or workpiece, and then press the blank line key (dry key). At this time, the spindle will not rotate, and the worktable will run automatically according to the program track. At this time, you can find out whether the deep hole drill may collide with the workpiece or fixture. But in this case, it is necessary to ensure that the deep hole drill cannot be installed when the workpiece is installed; when the tool is installed, the workpiece cannot be installed, otherwise a collision will occur.

3. Before starting the machine bed, the reference point of the deep hole drill bit needs to be set correctly.

With the continuous development of electronic products, the miniaturization of electronic products and the aperture of high-precision circuit boards are getting smaller and smaller. Therefore, the diameter of the hole on the printed circuit board is also reduced accordingly, and the traditional low-speed drilling method cannot meet the requirements. Therefore, the high-speed deep hole drill method should be used for the processing of small holes. Both sides of the bed are protected, and the above-ground fuel tank structure is adopted to improve the machine tool environment.

The use of deep hole drill beds has been used in more and more occasions. I don't know how much the user knows about the maintenance of the deep hole drill bit. Only proper maintenance can make it long. Let's take a look at it in detail: when leaving the deep hole drilling machine, you need to stop (flameout) to avoid accidents caused by unmanned operation. After the operation is completed, it should be cleared.deep hole drill bitWipe the surface of the rail with cotton yarn and add lubricating oil.